IPv4 network Subnet mask: IP address mask that identifies the range of IP addresses in the subnet where the appliance is connected.Ensure that you read the prerequisites before you configure the network settings. Depending on the type of network you have selected (IPv4 or IPv6), provide the following information to configure the network settings. In the Network Configuration page, you can select either IPv4 or IPv6-enabled networks. Then, enter the IP addresses for the separate management and backup network settings.įor more information about the IP range for the separate management network, see the IDPA 2.6 Installation Guide.ħ. In the Network Configuration page, if you want to configure the separate management network, click the Separate Management Network check box. The Network Configuration page is displayed.Ħ. Read the End User License Agreement and click I agree in the page to continue the deployment. The End User License Agreement page is displayed.ĥ. Create Security Officer User:Enter the user details in the following fields:.The Security Officer User information is not maintained in ACM. Note: The customer must maintain the following password. Change Appliance Password: Enter the password details in the following fields.After you change the password, the system automatically logs out and prompts you to log in with the new password. Note: The password set in the following step applies to all components of the IDPA appliance. Enter information for the following sections, and then click Submit. Note: Check if a preupdate patch is available on the Dell Support site for the version that you are installing.Ĥ. Read the information that is displayed on the Pre-Update Check dialog box and click OK.The Pre-Update Check dialog box in the Change Appliance Password page is displayed. ![]() ![]() Enter Username and Password in the respective fields and click Login.Open a browser and enter to access the ACM UI.The other models are preconfigured and installed by the Professional Services (PS) team. Note: This procedure is applicable for the IDPA DP4400 model. ![]() To install and deploy the IDPA appliance, complete the following steps. The user interface helps you set up IDPA and prepare the appliance for use. This section describes how to install and deploy the IDPA.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |